[Top] [Prev] [Next] [Contents] [Index]
MPEGPLAY Messages
MPEGPLAY messages pertain to video software support. If you are looking for a message that refers to the MPEGPLAY module but that does not appear here, refer to "Messages Common to All Modules".
BADENDCODE, Improper or missing sequence end code
- Severity:
- Fatal
- Explanation:
- The decoder could not find the MPEG I end code.
- User Action:
- Make sure that the file is terminated properly with the MPEG I
end code.
BADFLAG, Un-recognized flag flag
- Severity:
- Fatal
- Explanation:
- The user included an incorrect command-line option.
- User Action:
- Review the usage and syntax instructions in the command's
man page for the correct options and usage.
NODISPLAY, Could not open display
- Severity:
- Fatal
- Explanation:
- The application could not open the display.
- User Action:
- Make sure that the correct display is set by checking the
DISPLAY environment variable.
NOFILE, Could not open file file
- Severity:
- Fatal
- Explanation:
- The X server failed to open the file specified.
- User Action:
- Make sure that:
NOTMPEG, This is not an MPEG stream
- Severity:
- Fatal
- Explanation:
- The decoder could not find the MPEG I start code.
- User Action:
- Make sure that the file is either an MPEG I video stream or an
MPEG 1 interleaved audio and video stream.
PRIVCM, Using private colormap
- Severity:
- Information
- Explanation:
- The decoder installed a private colormap.
- User Action:
- None
[Top] [Prev] [Next] [Contents] [Index]
Send comments, suggestions, or questions about this document to the NCD Technical Publications Department by Internet e-mail. Write to us at
techpubs@ncd.com.
Copyright © 1997, NCD Inc. All rights
reserved.