[Top] [Prev] [Next] [Contents] [Index]
XRPRINTD Messages
XRPRINTD messages pertain to the XRemote print daemon. If you are looking for a message that refers to the XRPRINTD module but does not appear here, refer to "Messages Common to All Modules".
CLOSE, closed session on port
- Severity:
- Information
- Explanation:
- The print daemon closed the connection to the serial/parallel
daemon on the specified port.
- User Action:
- None
NOCONNECT, unable to connect to print daemon on port
- Severity:
- Error
- Explanation:
- The XRemote print daemon is unable to connect to the
serial/parallel daemon on the specified port.
- User Action:
- Make sure that the serial port mode (Setup -> Change Setup
Parameters -> Serial -> Serial Interfaces Table -> Current Port Use) has been
configured for printing.
OPEN, opened session on port
- Severity:
- Information
- Explanation:
- The print daemon connected to the Serial or Parallel daemon on
the specified port.
- User Action:
- None
[Top] [Prev] [Next] [Contents] [Index]
Send comments, suggestions, or questions about this document to the NCD Technical Publications Department by Internet e-mail. Write to us at
techpubs@ncd.com.
Copyright © 1997, NCD Inc. All rights
reserved.